Static IP address on MikroTik router

  • Connect your PC with MikroTik over Ethernet cable to Ethernet port 2-5
  • Setup IP address on your Network adapter as described in the picture
  • Open your web browser and type 10.10.10.1 to connect to the MikroTik Configuration web interface
  • Login with Admin/2n
  • Disable or remove DHCP client
  • Setup static IP address on Ethernet port 1
  • Add Default Gateway. Go to IP -> Routes -> Add New and setup like on following picture
  • Add IP addresses of DNS servers. Go to IP -> DNS -> Settings and setup all DNS servers

Regard's
Muhammad Waseem
+923007396305

Comments

Post a Comment

Popular posts from this blog

DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released

Image
DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released  Filed under: Radius Manager — Tags: dmasoftlab radius manager new version , radius manager 4.1 — Waseem Anjum Meo @ 10:47 AM             5 Votes Finally DMA has released its new version for Radius Manager Billing System. Complete info can be found here. http://www.dmasoftlab.com/cont/revision   *** v 4.1.0 *** 2013-10-23 *** NEW FEATURES: ↓ -enhanced SMTP mailer with authentication and freely configurable port -SMS alert indicating the account is going to expire ** This was most DEMANDED   , Jz -support for BulkSMS HTTP->SMS gateway ** This was most DEMANDED   , Jz -alert type is selectable in user preferences (ACP / UCP) ** This was most DEMANDED   , Jz -enable traffic report per user in ACP even if global traffic report is disabled -service change is allowed for Hotspot MAC accounts -auto logout expired ACP sessions -FreeRadius 2.2.0 support -DOCSIS u
Read more

How To Configure Nano Station M2 As Access point

Image
Web Configuration Now that the hardware has been completely installed, it's time to configure the Bullet to act as a WiFi Access Point. Configuration is performed using your web browser by typing in  https://192.168.1.20 . You'll get a warning pop up stating that the device has presented an invalid SSL certificate due to the certificate being self-signed and not issued by a CA. This is normal so just hit accept/continue. You'll then need to log in with the default username and password of "ubnt". Configure the Wireless tab The first step is to configure the Wireless tab so the Bullet acts as a WiFi Access Point. Change the settings according to the below picture. Be sure to set the device up with WPA2 security and an appropriate WiFi password here. You can also use this tab to adjust the power output should you wish to cover a smaller area. The default channel bandwidth is 40MHz, but some older devices such as wireless printers and mobile phones cannot o
Read more