RB750/750G Auto Time Update (NTP Client)


NTP Asia Pool Servers :  http://www.pool.ntp.org/zone/asia
I noticed each time after the router reboot or power on/off, the router's clock time & date will be gone.  The following guide will use NTP Client method to auto update the router's time.
Please note the router must be connected to internet in order to validate and get the correct NTP servers.

Go to System --> NTP Client

Enter the following information, please refer to the above link for the correct timezone NTP servers.
Click OK when done.



    Comments

    Post a Comment

    Popular posts from this blog

    DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released

    Image
    DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released  Filed under: Radius Manager — Tags: dmasoftlab radius manager new version , radius manager 4.1 — Waseem Anjum Meo @ 10:47 AM             5 Votes Finally DMA has released its new version for Radius Manager Billing System. Complete info can be found here. http://www.dmasoftlab.com/cont/revision   *** v 4.1.0 *** 2013-10-23 *** NEW FEATURES: ↓ -enhanced SMTP mailer with authentication and freely configurable port -SMS alert indicating the account is going to expire ** This was most DEMANDED   , Jz -support for BulkSMS HTTP->SMS gateway ** This was most DEMANDED   , Jz -alert type is selectable in user preferences (ACP / UCP) ** This was most DEMANDED   , Jz -enable traffic report per user in ACP even if global traffic report is disabled -service change is allowed for Hotspot MAC accounts -auto logout expi...
    Read more

    How To Configure Nano Station M2 As Access point

    Image
    Web Configuration Now that the hardware has been completely installed, it's time to configure the Bullet to act as a WiFi Access Point. Configuration is performed using your web browser by typing in  https://192.168.1.20 . You'll get a warning pop up stating that the device has presented an invalid SSL certificate due to the certificate being self-signed and not issued by a CA. This is normal so just hit accept/continue. You'll then need to log in with the default username and password of "ubnt". Configure the Wireless tab The first step is to configure the Wireless tab so the Bullet acts as a WiFi Access Point. Change the settings according to the below picture. Be sure to set the device up with WPA2 security and an appropriate WiFi password here. You can also use this tab to adjust the power output should you wish to cover a smaller area. The default channel bandwidth is 40MHz, but some older devices such as wireless printers and mobile phones cannot o...
    Read more