Ubiquiti PicoStation M2 basic wds repeater mode settings.

logo_ubiquiti
pico
Step 1. Connected the Ubiquiti PicoM2 to a computer using a CAT5 Ethernet cable.
Step 2. Open firefox or Chrome web-browser and type the default IP address 192.168.1.20 into the web address bar,   and make sure your computer is in the same IP address range, example 192.168.1.22 and you will see a login web page   like the picture below.
login
Step 3. Login with the default Username and Password. Username = ubnt. Password = ubnt and select your country and language and tick the “I agree to these terms of use” and click on the login button.
Step 4. Go to the Wireless tab and follow the steps as indicated in the following screenshot.
asdasd

Comments

Post a Comment

Popular posts from this blog

DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released

Image
DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released  Filed under: Radius Manager — Tags: dmasoftlab radius manager new version , radius manager 4.1 — Waseem Anjum Meo @ 10:47 AM             5 Votes Finally DMA has released its new version for Radius Manager Billing System. Complete info can be found here. http://www.dmasoftlab.com/cont/revision   *** v 4.1.0 *** 2013-10-23 *** NEW FEATURES: ↓ -enhanced SMTP mailer with authentication and freely configurable port -SMS alert indicating the account is going to expire ** This was most DEMANDED   , Jz -support for BulkSMS HTTP->SMS gateway ** This was most DEMANDED   , Jz -alert type is selectable in user preferences (ACP / UCP) ** This was most DEMANDED   , Jz -enable traffic report per user in ACP even if global traffic report is disabled -service change is allowed for Hotspot MAC accounts -auto logout expired ACP sessions -FreeRadius 2.2.0 support -DOCSIS u
Read more

How To Configure Nano Station M2 As Access point

Image
Web Configuration Now that the hardware has been completely installed, it's time to configure the Bullet to act as a WiFi Access Point. Configuration is performed using your web browser by typing in  https://192.168.1.20 . You'll get a warning pop up stating that the device has presented an invalid SSL certificate due to the certificate being self-signed and not issued by a CA. This is normal so just hit accept/continue. You'll then need to log in with the default username and password of "ubnt". Configure the Wireless tab The first step is to configure the Wireless tab so the Bullet acts as a WiFi Access Point. Change the settings according to the below picture. Be sure to set the device up with WPA2 security and an appropriate WiFi password here. You can also use this tab to adjust the power output should you wish to cover a smaller area. The default channel bandwidth is 40MHz, but some older devices such as wireless printers and mobile phones cannot o
Read more