How to setup 3G PPPOE connection on MikroTik



Step 1 : Make sure you connect your 3G USB dongle or simcard with the 3G wireless card module to the Router board, then click on Interfaces, then you will see the PPP connection. Now we need to configure the PPP connection. Double click on PPP interface.
1



















Step 2 : Change the APN to “internet”. Under pin, Insert your pin of your simcard, then change the data channel to 3 and info channel to 2 and press apply and OK. The data and info channels are different depending on the network you are using so you can always change the data and info channels for the device to connect properly.
2




















Step 3 : Go to the PPP tab and next to Phone, type the dial command “*99#”, some installers use different dial commands depending on the network. Un tick the Dial on demand tick box and apply the settings and press OK.
3















Step 4 : Go to IP>DNS and click on DNS
4

















Step 5 : Under the static tab, press settings and tick allow remote requests. Apply the settings and click on OK.
5















Step 6 : Go to IP > Firewall, then click on the NAT tab, and click on the red plus button to add a new rule.
6























Step 7 : Under the General tab, click on the drop down list next to Chain, and select “srcnat”, then go to the Action tab.
7






















Step 8 : Click on the dropdown list next to Action and select masquerade. Press apply to apply the settings and press OK.
8






















Step 9 : Now you should be able to see your masquerade rule as shown on the below picture.
9

Comments

Post a Comment

Popular posts from this blog

DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released

Image
DMASOFTLAB RADIUS MANAGER BILLING SYSTEM v 4.1 Finally Released  Filed under: Radius Manager — Tags: dmasoftlab radius manager new version , radius manager 4.1 — Waseem Anjum Meo @ 10:47 AM             5 Votes Finally DMA has released its new version for Radius Manager Billing System. Complete info can be found here. http://www.dmasoftlab.com/cont/revision   *** v 4.1.0 *** 2013-10-23 *** NEW FEATURES: ↓ -enhanced SMTP mailer with authentication and freely configurable port -SMS alert indicating the account is going to expire ** This was most DEMANDED   , Jz -support for BulkSMS HTTP->SMS gateway ** This was most DEMANDED   , Jz -alert type is selectable in user preferences (ACP / UCP) ** This was most DEMANDED   , Jz -enable traffic report per user in ACP even if global traffic report is disabled -service change is allowed for Hotspot MAC accounts -auto logout expired ACP sessions -FreeRadius 2.2.0 support -DOCSIS u
Read more

How To Configure Nano Station M2 As Access point

Image
Web Configuration Now that the hardware has been completely installed, it's time to configure the Bullet to act as a WiFi Access Point. Configuration is performed using your web browser by typing in  https://192.168.1.20 . You'll get a warning pop up stating that the device has presented an invalid SSL certificate due to the certificate being self-signed and not issued by a CA. This is normal so just hit accept/continue. You'll then need to log in with the default username and password of "ubnt". Configure the Wireless tab The first step is to configure the Wireless tab so the Bullet acts as a WiFi Access Point. Change the settings according to the below picture. Be sure to set the device up with WPA2 security and an appropriate WiFi password here. You can also use this tab to adjust the power output should you wish to cover a smaller area. The default channel bandwidth is 40MHz, but some older devices such as wireless printers and mobile phones cannot o
Read more